General Category > Technical

Rough running 1150GS

<< < (2/2)

pvlietstra:
Could not find any silicon wire locally (Port Elizabeth, South Africa), but have ordered a 100m roll of 0.5mm2 on-line. In the meantime, I taped up the existing wiring, adding a little extra insulation at the connections, and so far the bike is going well.
I have also found a supplier for the CYHME56 and have measured up the back plate for lazer cutting.  I may just make-up a spare assembly, test it and keep my original as a spare.
I did not reset the timing. I made a mark on the backplate and put it back in the same position.

Jughead:
Any luck with this?

pvlietstra:
Latest update.
The silicon wire was out of stock. The intermittent problem re-appeared.
I then replace one plug cap and both spark plugs (less than 3000km since service).
I have not had the problem since. The spare hall effect plate project is now on the back burner.

Navigation

[0] Message Index

[*] Previous page