General Category > R1200 models
ews fault gs911 won't read or accept vin vin
harmonzo1:
hi wayne - i've left a message at crossroadz
WayneC:
--- Quote from: harmonzo1 on April 05, 2021, 02:55:19 AM ---hi wayne - i've left a message at crossroadz
--- End quote ---
Responded to your message, check your inbox or junk email folder
Wilco:
Scanned your support ticket.
Looks like comms cannot be initiated with any of the controllers. This is highly unusual if actually caused by faults on the EWS, as the behaviour is similar to controllers simply not being powered.
If it wasn't for the partial autsocan being returned I'd have said the GS-911 might as well be talking to a brick...
harmonzo1:
i delivered my dead bike to the bmw dealer in mid may and i got the working bike back last week. (520kms round trip)
long story short - the bmsk module had failed.
i hope to retry my gs911 in the next few days.
WayneC:
--- Quote from: harmonzo1 on August 04, 2021, 12:59:53 PM ---i delivered my dead bike to the bmw dealer in mid may and i got the working bike back last week. (520kms round trip)
long story short - the bmsk module had failed.
i hope to retry my gs911 in the next few days.
--- End quote ---
Good to hear it is resolved, sounds like EWS components failed or corrupted, I have a BMS-KP here which autoscans OK but has an EWS fault
Navigation
[0] Message Index
[*] Previous page
Go to full version