Author Topic: K67 S1000RR Faults  (Read 8879 times)

ferreiradean12

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
K67 S1000RR Faults
« on: October 13, 2020, 10:49:57 AM »
Good day,

Could anybody please advise which sensor these faults relate to?


3A1A43   CY327, Internal voltage supply Sensor 2, undervoltage
The fault is currently present.
3A1A40   CY327, Internal voltage supply Sensor 2, voltage error
The fault is currently present.
3A1A42   CY327, Internal voltage supply Sensor 2, short circuit to ground
The fault is currently present.

Thanks in advance!

schuppi

  • Hero Member
  • *****
  • Posts: 558
  • Karma: +21/-0
Re: K67 S1000RR Faults
« Reply #1 on: October 13, 2020, 09:26:04 PM »
Hello
The DME detects a voltage deviation in the 5 V power supply of the component group 4.
The voltage supply to component group 4 is switched off if the permitted deviation is exceeded.

Disconnect all components listed below and clear the fault memory.
If, once all components are disconnected, the fault entry then is
a permanent fault: Check wiring harness for insulation damage.
not a permanent fault: Successively connect each component again until the fault is entered again.
Components in component group 4:
Gear selector sensor
Gearshift lever sensor (if installed)

Fault Impact
Gear display not plausible.
Engine can only be started with the clutch pedal depressed.

For further informations : http://bmwfault.codes/
Schönen Tag
Wolfgang
                                       talk less, drive more

ferreiradean12

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
Re: K67 S1000RR Faults
« Reply #2 on: October 16, 2020, 11:25:22 AM »
Hi Schuppi,

Thank you for the assistance, I found the problem by unplugging all sensors at a time and was indeed the shift assistant that was faulty.

Much appreciated!