General Category > ezCAN
New feature requests for ezCAN ?
solar-g:
Ezcan new features please:
1. Separate "ignition on" &/or "turn-off delay" for each of multiple outlet circuits.
I have 2 Accessory outlets for Ezcan, one for Innov K2, other for aux work light for camp site.
I'd like the K2 with max shutoff delay when ignition turned off; the aux campsite light to be non-ignition circuit (always on), so can be on without engine if I want.
2. Low voltage disconnect for non-ignition accessory circuits, programmable for voltage value below which circuit turns off. eg: LED campsite light off if voltage drops to 12.0V
Fintrum:
So the kit works fine, lights light up and turn off as per, what is a pain is that to program the ezcan require the unit to plugged into a laptop!
I remember laptops, they were in fashion a few decades ago, werent they?
So how about either a phone app that can be bluetoothed to the excan, or even some way of plugging an ipad pysically into the box of magic stuff??
Or have I misse the launch of said items? (phone app best tho!
a new comer to the forum
Boris:
The KTM 890 Adv does not have a hazard flasher.
Would it be possible to add this functionality using the aux lights in the front and additional Brake light. Set them to strobe at a slowish rate and adjustable brightness, or just 100%? - say activated by three presses of the Turn signal cancellation
TheRealDukeSchneider:
--- Quote from: Fintrum on November 08, 2021, 06:59:26 PM ---So the kit works fine, lights light up and turn off as per, what is a pain is that to program the ezcan require the unit to plugged into a laptop!
I remember laptops, they were in fashion a few decades ago, werent they?
So how about either a phone app that can be bluetoothed to the excan, or even some way of plugging an ipad pysically into the box of magic stuff??
Or have I misse the launch of said items? (phone app best tho!
a new comer to the forum
--- End quote ---
I second the request for bluetooth or wifi to allow program from ios/android device.
I am planning to set up a complete workshop with TV/Monitor for viewing manuals, etc. I just bought the GS-911/wifi to use in the shope and on the road. It would be a really convenient feature to have access the EZ Can in the shop over wifi or bluetooth. Tech has hit a point where it is becoming commonplace to use a tablet/phone as your only device. I am lucky to have "an old" laptop laying around for shop use but would prefer not to have too. Please and thank you. Love your products so far. EZCAN is overall fantastic to make my bike much safer with accessory lighting on front and back.
2011 R1200RT (and loving it!)
BradB:
I want to 2nd the request for a delayed accessory power-up after the ignition is turned on. Thanks!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version