General Category > Central Vehicle Electronics/ZFE/GM issues

K1600GTLheadlight issue

(1/1)

dsellers:
I'm getting this error code and wonder exactly what it is.
Is it a problem with the headlight itself, or the controller?

1 fault codes found:

E11430   CAN message missing (headlight status from SWE unit)
The fault is currently present.

Thanks,
Dave S.

e7navy1999:
Good Afternoon,  What was the final solution?  I am getting an intermittent headlight code but only when I hit bumps

Ruan:
Hi e7navy1999

The fault code service plan is very vague, you can check it out with the following website, just remember to remove any spaces before searching the fault code:
https://bmwfault.codes/

Check CAN bus, power supply and operation of transmit control unit.

Kind regards
Ruan

e7navy1999:
Thanks.  I since replaced my front Genuine OEM BMW K1600GTL Front Level Sensor 37146860843 located just to the left side (rider right side0 behind the front spring.  No more fault codes.  I purchased a used part from ebay for $35usd.  took about 30 minutes to replace, had to remove front wheel but it may be possible without so much effort.  I replaced all my 6 coils at the same time at 100k US Miles.  engine fault code is gone.  Coils 2 and 3 were faulting since two months ago

Navigation

[0] Message Index