General Category > Central Vehicle Electronics/ZFE/GM issues

ESA Calibration error

<< < (3/3)

Jughead:

--- Quote from: Nick Evans on June 27, 2020, 01:23:38 PM ---The good news, the shock I have just put back in (following a rebuild by Firefox Racing) was succesfully calibrated and I can see the preload changing when I ask it to. When I try to calibrate the front shock I get the following message "Negative response from controller: conditions not correct or incorrect sequence of commands".

--- End quote ---

According to your post above, everything is working as it should.  The calibration as I understand it is not for the rebound.  Calibration sets up the preload only.

If you can calibrate the rear preload, then it is working.  If you cannot calibrate the front preload, maybe that is because you do not have preload in the front.

Navigation

[0] Message Index

[*] Previous page