General Category > R1200 models

Alarm

<< < (3/4) > >>

Beagler:
DWA........ DiebstahlWarnAnlage = Theft Warning Device.

I think it may be the alarm batteries but thought they should last longer than the 2.5 years of the bike. Any one change theirs and how long did they last.

But

Not got the DWA battery low warning on the dash.

Or

It could be just that the alarm has been triggered?


XDWA : -[/size]Controller Type : Anti-Theft AlarmController Name : XDWAController : 0F8700Manufacturer : META System S.P.A.Manufacture Date (YY/MM/DD) : 17/05/08VIN : Z263457Program Count : 0Program Count Maximum : 1024Firmware Date (YY/MM/DD) : 17/05/08Kilometers when programmed : 0.00 Number of FW configurations : 4..HW Electronics (HWEL) : ....Firmware ID : 0A4C....Firmware Version : 001.000.000..Bootloader (BTLD) : ....Firmware ID : 0A49....Firmware Version : 001.000.000..SW Memory Image (SWFL) : ....Firmware ID : 0A4A....Firmware Version : 001.006.003..Coding Data (CAFD) : ....Firmware ID : 0A4B....Firmware Version : 002.000.000Fault Codes : 1

Beagler:
Took batteries out and both are 3.4v so unlikely them. Will change them anyway.

Beagler:
Changed batteries to Duracells and they were 3.2 volts new. Cleared fault, Switched alarm on and off and rescanned and as below fault gone. Wonder if it was batteries too high voltage at 3.4 or something


XDWA : -
Controller Type : Anti-Theft Alarm
Controller Name : XDWA
Controller : 0F8700
Manufacturer : META System S.P.A.
Manufacture Date (YY/MM/DD) : 17/05/08
VIN :
Program Count : 0
Program Count Maximum : 1024
Firmware Date (YY/MM/DD) : 17/05/08
Kilometers when programmed : 0.00
Number of FW configurations : 4
..HW Electronics (HWEL) :
....Firmware ID : 0A4C
....Firmware Version : 001.000.000
..Bootloader (BTLD) :
....Firmware ID : 0A49
....Firmware Version : 001.000.000
..SW Memory Image (SWFL) :
....Firmware ID : 0A4A
....Firmware Version : 001.006.003
..Coding Data (CAFD) :
....Firmware ID : 0A4B
....Firmware Version : 002.000.000
Fault Codes : 0
No Faults found :

meintjiesj:
Got same error when I scanned my 2013 GS, newly acquired 10k miles. Error Code 1. Nothing else. Will try swapping the barrettes as you did.
Alarm works fine otherwise.

Beagler:
Error came back not battery. The alarm test is not included yet but will be. I read a list of tests it covers but cant remember where. You have to live with it till updated and included I think.

Navigation

[0] Message Index

[#] Next page

[*] Previous page