Author Topic: R1200 2006 Oil Light Flashing prior to starting the bike  (Read 4177 times)

mike d

  • Full Member
  • ***
  • Posts: 133
  • Karma: +3/-0
R1200 2006 Oil Light Flashing prior to starting the bike
« on: February 11, 2020, 07:39:39 PM »
Hi Guys,

A club member in the UK has just bought a 2006 R1200R with 9000 miles on the clock. He serviced it. When the ignition switch is switched on the warning lights come on, the system runs a quick check and needles go around on the two clocks as it is supposed to.
However, before the engine is started the oil light starts flashing quickly and then immediately goes out when the engine starts. Plenty of oil in the engine.

I understood that this is an indication of low pressure?

A GS-911 was connected up, but no faults were listed. The Factory I-level reads K024-06-08-500 and Actual I-level not set.

On some 1200s there is a sensor to tell that oil is low and it flashes. This engine does not have the mounting hole on the right hand side beside the engine number. The sensor part no. is 13627673502.  Motorworks no. ENE73502 which cannot be fitted to the 1200R.

A fellow club member has the same year bike and his oil light does not flash.

Any suggestions?

Regards

Mike
     

WayneC

  • Beta testers
  • Hero Member
  • *
  • Posts: 1439
  • Karma: +32/-1
Re: R1200 2006 Oil Light Flashing prior to starting the bike
« Reply #1 on: February 12, 2020, 01:47:28 AM »
Mike
Take a look & see if it has a conventional oil pressure switch to operate the dash warning lamp, if so that type of switch can develop faults causing lamp flash, have seen similar on the 650GS models, the cure is simple, replace the switch

mike d

  • Full Member
  • ***
  • Posts: 133
  • Karma: +3/-0
Re: R1200 2006 Oil Light Flashing prior to starting the bike
« Reply #2 on: February 12, 2020, 10:28:02 AM »
Hi Wayne,

Thanks for the prompt response. I have just sent it to him to check out.

Mike

Skim

  • Jr. Member
  • **
  • Posts: 68
  • Karma: +0/-0
Re: R1200 2006 Oil Light Flashing prior to starting the bike
« Reply #3 on: February 12, 2020, 12:47:36 PM »
Hi Mike,
Interesting. Please give feedback if you can.

mike d

  • Full Member
  • ***
  • Posts: 133
  • Karma: +3/-0
Re: R1200 2006 Oil Light Flashing prior to starting the bike
« Reply #4 on: February 12, 2020, 07:00:44 PM »
Hi All,

Apparently the sender unit was the first thing to be changed, it's a single wired sender unit,  no difference when changed.

Mike

WayneC

  • Beta testers
  • Hero Member
  • *
  • Posts: 1439
  • Karma: +32/-1
Re: R1200 2006 Oil Light Flashing prior to starting the bike
« Reply #5 on: February 13, 2020, 09:33:51 AM »
Hi All,

Apparently the sender unit was the first thing to be changed, it's a single wired sender unit,  no difference when changed.

Mike

Understood, check if they bought a new BMW unit, some after market senders have shown lamp flashing including at higher rpm

mike d

  • Full Member
  • ***
  • Posts: 133
  • Karma: +3/-0
Re: R1200 2006 Oil Light Flashing prior to starting the bike
« Reply #6 on: February 13, 2020, 10:05:18 AM »
Thanks Wayne, response passed on.

Mike