General Category > General Discussion

iGNITION VOLTAGE

<< < (2/2)

Jughead:
Is your sidestand switch connected?  These bikes will not run without it.  In other words, if it is connected and faulty, the bike will not run.  If you unplug it, the bike will not run.  You need to unplug it and short it out on the harness plug.  I would suggest doing that to eliminate it from the system.  They are prone to failure.

The only diagram I have is for the single spark 1150 unfortunately.  Will browse around and see what I can lay my dirty little paws on.

Jughead:
Have a look here.  I know it is for an RT, but just ignore the reference to the electric screen and radio.  The remainder is exactly the same.

https://www.mac-pac.org/wp-content/uploads/2014/09/R1150RT-2-Plug-Elec-Diagram-V1_3.pdf

Scarfey49:
Looks like the GS911 analyser did the trick. When I replaced the HES I made the cable too thick and the mounting plate wasn't all the way home allowing the pulley to rub on one of the HES negating its magnetic effect. The bike relys on the HES to tell the ECU to turn the fuel pump relay on and also the ignition. So with one not operating no spark or fuel. The problem was when I took the pulley off and tested them using a hacksaw blade the problem disappeared. Haven't started it yet but confident never the less.

WATCH THIS SPACE

Jughead:

--- Quote from: Scarfey49 on November 22, 2019, 12:25:18 PM ---Looks like the GS911 analyser did the trick. When I replaced the HES I made the cable too thick and the mounting plate wasn't all the way home allowing the pulley to rub on one of the HES negating its magnetic effect. The bike relys on the HES to tell the ECU to turn the fuel pump relay on and also the ignition. So with one not operating no spark or fuel. The problem was when I took the pulley off and tested them using a hacksaw blade the problem disappeared. Haven't started it yet but confident never the less.

WATCH THIS SPACE

--- End quote ---

[emoji106]

Scarfey49:
Well folks I got it running but only on one cylinder. An injector died. I’m not sure wether I should get an award for incompetence or persistence. Thanks for your help.  New injector on the way.
😂😂😂😂😂😂😂

Navigation

[0] Message Index

[*] Previous page