General Category > General Discussion

adaptations reset question euro4 wethead boxer

<< < (2/3) > >>

Mornay:
Just to be on the safe side I'd leave it until the fan goes on. This way you'll ensure all values are learnt while engine is at operating temps

GvG:
Thanks Mornay. but now a have another "problem";

I tried resetting the values today, but obviously I have a XBMSMP1 controller and not a BMS-X controller (I have a R1200RT LC '18) and therefore cannot reset the adaptation values because it doesn't show on the screen  :(. I only can read and clear fault codes and see realtime values  >:(

Is there going to be an update so I properly can use my GS-911?

Thanks in advance.

Mornay:
Ah - when you mentioned euro4 I should have suspected a XBMSMP1 controller.

We are planning on adding this to future revisions via a software update, however no clear release date is available yet...

Mornay:
You should be able to use the GS-911 to reset your quickshifter though.

GvG:
Well, I couldn't found the "reset transmission" button.

I could see the green light on the GS-911 was still flickering/flashing, even with ignition on (engine not running); is that normal or should the green light be steady?
I could still perform a Autoscan and read and clear fault codes  ::)

Navigation

[0] Message Index

[#] Next page

[*] Previous page