General Category > ABS related issues

1200RT flushed brakes now error codes appear?

<< < (2/2)

schuppi:
There are 6 bleed nipples on the pump, 3 for the front and 3 for the rear.  They are not in order!

Hello

Bleeding the control circuit as BMW-Motorrad recommended:
Bleeding

In the following sequence
Front metering cylinder  1
Front integral circuit  2
Front integral circuit  3
and again
Front metering cylinder  1

1. slowly operate brake lever until brake light switch clicks (blow-by bore closed)
2. open the bleed screw
3. slowly operate brake lever to full extent of its travel and close bleed screw
4. slowly release the brake lever
5. repeat steps 1-4 until the brake fluid emerges clear and free of bubbles
6. be sure that the reservoir is allways filled with new brake fluid

Same procedure for the rear control circuit!

Blackamati:
Hi guys, thank goodness I asked you otherwise I would have started on the GS1200 with servo not realising what a minefield it was.....or is😱
You have given such clear instructions all should be possible.

Jughead:
[emoji106]

Navigation

[0] Message Index

[*] Previous page

Go to full version