General Category > General Discussion
tpms sensor id
Mornay:
If you do not have access to any wakeup tools, you can use the ALERT method as a last resort, also detailed on the RDC procedure page (Option 3). This should wake the sensor up and the GS-911wifi should then be able to read the sensor ID's.
BALVIAMBE:
Boss
am going to try this once i reach home and let u know as soon as i get the results boss.
BALVIAMBE:
Hi,
did not work out tried 3 times.
1. i tried removing air from 1 tire at a time did not work and also went on a short ride again.
dash lights did not come up but still -- -- sign is there.
2. removed air from both the tire at same time went on short ride.
dash lights have not come up but still -- -- is there.
3. without removing air from tires tried to relearn the sensors it took more then 10 minutes but no error sign nor message.
drove the bike for more 10 kilometers at a speed between 30 km and 35 km with no stop.
still on dash no lights have come up and the sign is -- --.
pls assit used the 3 pro...
As the sensors are still active for a while before going to sleep, your first thought would be to take the bike for a short ride, thus waking the sensors and allowing you to learn a sensor.. This however is NOT THE RIGHT WAY!! This will wake both sensors and when you instruct your RDC unit to learn a specific position, e.g. front wheel, Set A, the control unit will be receiving signals from both active TPM sensors and might not learn the right one, or any for that matter...
THE CORRECT ALTERNATIVE, also known as the "ALERT method" is to let the air out of the wheel rapidly (we simply depress the valve for around 10 seconds)... this rapid fall in pressure wakes the sensor and places it in an Alert mode, where it starts sending its data (which obviously includes its Sensor ID!).
Thus, to summarize, if you do not have a RDC wake-up tool, either enter the new Sensor ID manually in the Advance section (this of course assumes you noted the Sensor ID before refitting the wheel ;-) ), or when the GS-911 application asks you to use the wake-up tool, simply depress the valve of the tire that you want to wake for around 10 seconds, which will in turn wake the sensor in an Alert mode where it then sends its Sensor ID and pressure information....
BALVIAMBE:
started learning for 35 minutes it was still learning only.
using phone it says sensor battery ok
using pc it says sensor battery not ok
which is correct don't know yet
bike is r1200gs lc 2016
INTERNET is connected but phone can not connect to cloud it say no INTERNET connection.
BALVIAMBE:
Hi Boss
this is the error message in picture.
481f8a
481f8b is it the tire sensor id's i was looking for.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version