General Category > General Discussion

tpms sensor id

<< < (4/7) > >>

Jughead:

--- Quote from: Mornay on July 20, 2017, 02:04:43 PM ---If you do not have access to any wakeup tools, you can use the ALERT method as a last resort, also detailed on the RDC procedure page (Option 3). This should wake the sensor up and the GS-911wifi should then be able to read the sensor ID's.

--- End quote ---

Mornay

I think his issue here is not being able to pick up the current sensor id as programmed.

The screenshot in the link (http://www.hexcode.co.za/products/gs-911/procedures/rdc) has the button for "Learn front sensor, wheel set A", alongside which the Current ID is displayed.

As per my previous post, I played around a little and managed to find where the current ID is displayed.

Maybe somewhere in the future the "Display Current ID" feature can be added?

Jughead:

--- Quote from: BALVIAMBE on July 25, 2017, 08:13:12 AM ---Hi Boss Jughead,
have to do from pc or phone.
if phone it tell me your are not connected to wifi but the phone shows connected
pls assist me more on this
Thx

--- End quote ---

The screenshot in the previous post was from the PC.  Here is one from the phone, a Samsung S8.

You must enable your mobile data while connected to WiFi.  Many phone are set to disable mobile data while connected to WiFi.

BALVIAMBE:
Hi,
this id shows but when u try to relearn they it takes more then 35 minutes still learning.
AM USING V1702.2 ON PC.

Jughead:
Why are you trying to relearn the ID?  The correct ID is already set up.

It is possible that the sensor batteries have died.

A question. Have you added a mousse or puncture prevention solution into the tyre?

BALVIAMBE:
Hi,
no it is new bike model 2016. mistake done was by me when traveling i removed the battery from bike for nearly 2 months and this problem came up.
the dash is reading "  -- --  "
and error message when it comes up is as follow.
this fault is on both tyres front and rear.

Navigation

[0] Message Index

[#] Next page

[*] Previous page