General Category > General Discussion
Self canceling turn signals..So how DO they work?
Mornay:
--- Quote from: e7navy1999 on June 30, 2019, 04:56:27 PM ---So if understand this thread correctly, If I have an older (pre-2015) K1600 I can change my turn signal count down with the GS-911????. if so, how do i do it?
--- End quote ---
The turn signal configuration is only available on the S1000 range pre-2015:
http://www.hexcode.co.za/products/gs-911/function_charts/kombi46_func_chart
net2phill:
Hi Hex Code Guys,
Just wondering if this is still on the roadmap. This is one of the few annoyances of my RT (there really aren't many), but if I can adjust that with the GS-911, wouldn't that be special!
It's OK if the functionality isn't there yet, but I'd just like to know that the effort to add it is still alive.
Thanks in advance!
Francois Barnard:
--- Quote from: net2phill on September 04, 2019, 07:27:31 PM ---Hi Hex Code Guys,
Just wondering if this is still on the roadmap. This is one of the few annoyances of my RT (there really aren't many), but if I can adjust that with the GS-911, wouldn't that be special!
It's OK if the functionality isn't there yet, but I'd just like to know that the effort to add it is still alive.
Thanks in advance!
--- End quote ---
Hi there,
Just to poke the interest again - this coding functionality indeed has been implemented for the newer K001 generation bikes where supported, but it is currently limited to beta users. We hope to have this released to general users once it has been thoroughly tested and validated.
Kind Regards,
FrancoisB
Guilherme:
Hi Alan,
The link you mentioned http://www.i-bmw.com/showthread.php?p=763856&posted=1#post763856 don't works.... unfortunately.
Dann:
FYI Turn signals have been modified on 2019 R1250RTs.
They turn off immediately after a turn like on a car.
I assume that the the bike detects the lean angle of a turn and turns the turn signal off when the bike straightens up. (That's a lot of 'turn' in the same sentence. ;) )
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version