General Category > R1150 models

Problems R1150GS - 2003

(1/1)

JOPE:
Dears,

I live in Mozambique (Matola),  i have new GS-911 wifi, It is excellent !…but i am hoping for some advice on this error combination on my R1150 GS 2003:

Codes faults:

272 : Intake Air Temperature Sensor Circuit, Open-circuit or Short-circuit to Positive.
Currently present : NO
Occurrence count : 0
|
821 : Hall sensor 1, no signal – this fault will always occur if engine not running or engine not cranked before reading Fault codes.
Currently present : YES
Occurrence count : 0
|
901 : Hall sensor 2, no signal – this fault will always occur if engine not running or engine not cranked before reading Fault codes.
Currently present : YES
Occurrence count : 0

16773 : Front wheel speed abnormal
Currently present : NO 
|
17910 : Brake fluid level too low
Currently present : NO

Can you help me please, any suggestions would be greatly appreciated!

Thank you.

João Diniz

schuppi:
Hello João
and welcome to GS911 forum.

Looks like you serviced your bike !

272
> disconnected sensor to open the airbox while ignition on
> delete fault code

821
> as GS911 required
> run engine and read again
> fault will disappear

901
> same as 821

16773
> difference between front and rear sensor readings
> running on centerstand with spinning wheel
> delete

17910
> brake bleeding? and didn't look for correct fluid level
> delete

After deleting fault codes run a test ride and read again while engine is running.
! Caution, pay attention for engine / oil temperature !

JOPE:
Hi Schuppi,

Thank many!  :D

Engines
No fault codes found

ABS INTEGRAL
No fault codes found

My bike is perfect!

Have a nice day!

João Diniz

Navigation

[0] Message Index