Author Topic: 24972 pressure in rear wheel circut  (Read 11950 times)

applegate

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
24972 pressure in rear wheel circut
« on: July 28, 2014, 12:41:23 PM »
Hi I have a ABS fault on my 2005 k1200s showing 24972 pressure in rear wheel circut is to high
and 24954 internalrol module error- analogue value, front pressure sensor.
Also the rear sevo motor keeps going when key turned off and to stop this I have to disconnect the battery

What do I need to do to fix this
« Last Edit: July 28, 2014, 12:47:38 PM by applegate »

beemer

  • Newbie
  • *
  • Posts: 11
  • Karma: +0/-0
Re: 24972 pressure in rear wheel circut
« Reply #1 on: July 28, 2014, 10:52:46 PM »
You have to replace plate with pressure sensors,for wheel circuit it's the one outside the unit,but you have to take the unit apart to route sensor wire correctly.

applegate

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
Re: 24972 pressure in rear wheel circut
« Reply #2 on: July 29, 2014, 06:08:59 AM »
so where will I get these from

beemer

  • Newbie
  • *
  • Posts: 11
  • Karma: +0/-0
Re: 24972 pressure in rear wheel circut
« Reply #3 on: July 29, 2014, 07:34:44 AM »
Unfortunately you can't get them new.Try to find second hand ABS modulator that someone removed due to a failure and hope that them sensors are ok.It could be any iABS modulator can bus/non can bus doesn't matter,sensors are the same.