General Category > General Discussion

Tracking battery voltage

(1/3) > >>

Dann:
I know that that the battery voltage is displayed at the bottom of the software window

What I would like to do is to log the realtime values of the battery voltage  when I start the bike.

The battery voltage does not show in the realtime values list. Only the alternator voltage can be selected.

How can I do this?

WayneC:
Knowing the model of the machine would be rather helpful  ;D

Dann:
R1200RT 2007   Sorry... :-[

I'm using the PC software with a USB cable (That might be helpful too  ;))

WayneC:
OK

There are two voltages in the diags interface on your model which are KL 30 (V-Bat) and KL 15 (Ign On) which could be monitored. I normally do any logging from a GS911 WiFi as it is easier without the PC interface and I have never been asked to look at your model so I am flying blind a bit here

I would expect you should turn on ignition, set up the logging with the PC interface, there should at least be KL15 available in the parameters to be logged, then start the bike to see the voltage changes

schuppi:
Hello

I would look in the real time datas of ZFE, there would be the voltage of "30" displayed and
can be logged.

Hope this helps

Navigation

[0] Message Index

[#] Next page