General Category > S Series

Lean Angle CAN bus problems!

<< < (2/2)

fotodadi:
Hey schuppi!

You are the man. Finally got to check all the pins/wiring out as you suggested and found that all is ok as per continuity. Pin4 however did not have 12V with ignition. I spliced it and got it fed 12V from the ABS module (which is only hot with ignition)

All problems disappeared. Bike is perfect! 8) 8)

Thank you so much for your help.

I wonder though what happened that I dont see 12V switched on Pin4. ::) ::)

schuppi:
GREAT!

You're welcome ;)

e7navy1999:
this whole time I was thinking the GS911 -9 lean angle was a fuel mixture issue.  It turns out the lean angle is the actual leaning of the bike.  is -9 lean angle ok on the center stand?  I am thinking in the USA we drive on the right had side of the road so the lean angle is offset to compensate?  and some other countries drive on the left side so the base lean angle would be maybe zeor or +9?  Just guessing

Navigation

[0] Message Index

[*] Previous page