General Category > General Discussion

Where is the prompt to add a new VIN

<< < (2/4) > >>

pharme:
The strange thing is that i seem to be able to activate the function tests (start and stop)like TPS adjustment, fuel pump relay, tank venting, hall sensor signal (this one not so sure) without receiving any prompting to key in VIN numbers. I have checked in the 'About' menu, my VIN has not been registered yet. I dont know to what extent with a registered VIN would these functions perform. Should i raise this to hexcode office?

WayneC:
If you can do the component test functions and it has not registered your VIN then it is acting as a Pro version, which PC software version are you using ?

pharme:
Here's my specs:

MacBook booted with Bootcamp Windows 10
USB connected with Yellow GS-911USB
on R1150GS Adventure.

I dont think I am in the PRO version as the About screen has the invite for the upgrade.
Can you tell me a little what service maintenance can a registered VIN account do where a non registered one cannot? Can a non registered piece do what I said in earlier mail?

WayneC:
I asked which version of GS911 PC software you were using but I dont see it in your spec, it has me intrigued

pharme:
ahhh, yes.

GS-911 version: 1603.1 Datapack version: 4.1
Firmware version: 0.21.C

Navigation

[0] Message Index

[#] Next page

[*] Previous page