General Category > General Discussion

Brake Test fail

<< < (3/5) > >>

bikecrazy5:
hi alex

is it only showing these faults on the brake test or in the autoscan

please post a auto scan so we can have a look.

regards
mike

Alexm1:
Mike, thanks for the response. The faults show in the auto scan, I have attached two files. (one in the following note)
1/ auto scan before any tests, 2013-08-08 10.55
2/ auto scan following both tests, 2013-08-08 11.00. Both faults are present. Note that the front brakes passed the test, the rear brakes did not pass the test. On the graph both turned green and the graph moved to within 2mm of the third division. Cannot find how to attach a second attachment so will add an extra note with the second autoscan.

Alexm1:
second auto scan

bikecrazy5:
hi alex
am I correct by assuming this is the servo assisted  abs unit[in other words makes a noise when applying brakes
have a look at the pressure valves they tend to get stuck with crud
http://forum.hexcode.co.za/forum/index.php/topic,4.msg177.html#msg177

Alexm1:
Bikecrazy5, thanks. I had seen that post of jugheads but had not thought to link it with my symptoms. I will continue to pursue a fix but given that I do not have any error conditions other than when I bring them on with the bleed test I won't take the ABS unit out yet.
Yes it is the servo assist model, 2003 K1200GT.
My current plan is to find the source of the low voltage, I am just waiting for the circuit diagrams.
Thanks for your input, appreciated.

Navigation

[0] Message Index

[#] Next page

[*] Previous page