General Category > K Series

Fuel gauge issues

<< < (3/3)

schuppi:
Hello,
but no further recommendations. What's about faults in other modules?

fotodadi:
Only these two faults in the engine controller.

2 fault codes found:
10116 Gear shift-lever sensor
The fault is currently present.
10313 Exhaust flap servomotor
The fault is currently present.

Surely that wouldn't interfere with the fuel gauge?

schuppi:
Hello

I think so, that wouldn't be the reason :-\
"Also did the real time values for the Fuel Sense voltage and the values showed a change that was consistent with the floater"
Where can you read this? I think RTV in the ZFE, then the datas will not be processed in the Kombi (cluster)
If the RTV are readable in Kombi > ZFE failed :-[

 RTV > real time values

fotodadi:
Hi,

Actually I can read the Real Time Values in the ZFE (Central Vehicle Electronics). The "Fuel Sense Voltage" is displayed in the real time values and I just read it as 0.24V and that's with an empty tank. This means ZFE is OK.

The is no possibility to read any real time values in the Kombi (Instrument Cluster except Battery voltage and Ambient Brightness.

Will have the bike ridden around with a full tank to ensure the floater does not move. Hopefully things will resolve. It's very strange though.

fotodadi:
Good news!!!

Had the bike ridden about. I think it did less than 50km with the tank FULL (and actually that's the only way to ensure that the floater does not move) and the display is now active again on the cluster.

Thanks you Schuppi!!! ;) ;) ;)

Navigation

[0] Message Index

[*] Previous page