General Category > General Discussion

Front wheel sensor

<< < (2/3) > >>

tomlowry:
XABS
Controller:   0F8300
Serial Number:   6033900166
Manufacturer:   Continental Automotive
Manufacture Date (YY/MM/DD):   13/09/17
Program Count:   0
Program Count Maximum:   1000
Firmware Date (YY/MM/DD):   13/09/17
Number of FW configurations:   3
HW Electronics (HWEL):   
   Firmware ID:   1299
   Firmware Version:   000.002.000
Bootloader (BTLD):   
   Firmware ID:   1298
   Firmware Version:   000.001.003
SW Memory Image (SWFL):   
   Firmware ID:   129A
   Firmware Version:   001.003.020


2 fault codes found:

480906   Wheel speed sensor, front, movement detection
The fault is not present now.
480860   Supply voltage, undervoltage
The fault is not present now.

schuppi:
Hello Tom,

This fault will be detected while:
Missing signal during starting process.

If the difference between the front and rear wheel speeds is too great over a long period of time during the starting process, a signal fault is assumed  >>>> while parking on stand and running 1. gear 8)

Conditions for entry: Faulty, damaged or soiled wheel speed sensor. Damaged or soiled sensor ring.
Air gap between wheel speed sensor and sensor ring too large.

You have to :
Check for correct installation of wheel speed sensor.
Check wheel speed sensor and sensor ring for dirt contamination.
Check air gap between wheel speed sensor and sensor ring.

But I think that's not a real fault, you are only playing with your bike using GS911.........sorry

tomlowry:
wheel sensor seams to be ground down a little, gap from sensor to wheel thingy is about 2mm. took sensor of and held it closer to thingy, still no movement on gs911 front wheel dectection bit. Would the fact that it appears to be ground down a little make it unusable?

T

GS Jim:
The gap should be closer to 1 mm, the sensor needs to see the slots in the ring go past the sensor, the controller takes the frequency of the passing slots and bars and uses that to calculate wheel speed. Elevate the front wheel (not a wheelie) and spin the wheel by hand while you are in real time values on the GS911, you should get a reading on the sensor while spinning wheel.

tomlowry:
reading on rear wheel no reading on front. I have ordered a good as new one on ebay. Will post results when i get it on. Thanks All

Navigation

[0] Message Index

[#] Next page

[*] Previous page