General Category > General Discussion

Front wheel sensor

(1/3) > >>

tomlowry:
Hi All, 2014 r1200gs lc k50, ABS has been faulty for quite a while, too many fault codes on bike, since 2 years. I have reset codes, and when i run engine on stand in first gear, i can see the rear wheel speed from the gs911 output live. When spinning front wheel by hand, i get no out put. Is my sensor faulty or am i not getting enough revolutions to activate? Only got 911 tonight so not sure whats what just yet.

Thanks tom

tomlowry:
just to add, when i run the function on the abs with the gs911, i here the pump doing its stuff.  Tom

tomlowry:
I have turned the rear wheel by hand and I get a reading, so i am pretty confident I have an issue with my front wheel sensor. will strip at the weekend and check. Can anyone confirm if this will give me ABS faults?  Ta Tom

schuppi:
Hi Tom
I think a full Auto-Scan would help to find it out.

GS Jim:
Hi Tom, I have a 2015 R1200 GS and just the slightest spin by hand gives me several kph of wheel speed front and back, no need to put in gear or have engine running, what is the signal strength of the sensors, and like schuppi says post a scan.

Navigation

[0] Message Index

[#] Next page