General Category > Engine related issues

Ignition off fault

(1/2) > >>

GSNam:
Good day all

Have been struggling to get my 2006 Dakar to start.

Got my GS911 Blu Enthusiast today and installed all software correctly. It works on my Android cellphone and on my laptop. By that I mean that both devices recognises the GS911 and I can see my motorcycle info ( serial no., build date etc. )

If, however, I select my motorcycle model,  a message comes up :

Error

Detected the following problem:
Failed to read contoller info: No response from controller, check that the :
Ignition is on
Kill switch is in the RUN position,
etc, etc

If I then continue with the diagnostic run and select Engine, ECU info ( or any other function ) another message comes up that the ignition is off and there is no response from the controller.

The ignition is clearly on and the GS gets power from the bike alone as well. No wires are off inside the kill switch.

Would really appreciate any help!!

Cheers,
Heino

Sent from my SM-T531 using Tapatalk

GSNam:
Oh yeah. On the laptop screen ( bottom right) it also indicates the same fault:
VIGN 0V (off )
Though VBAT: 12.6V

Fuses are good.



Sent from my SM-T531 using Tapatalk

GSNam:
Ok, had a stupid moment. Wayne explained that the Dakar will show no ignition as it is not wired like that out of the socket.

Thanks!!

Sent from my SM-T531 using Tapatalk

schuppi:
Hello Heino,

VIGN 0V (off ) maybe one thing you can ignore, because there is no cable for "15" in diagnostic connector :)

Please pull the injector connector and check the red/yellow cable for 12V and more, ignition on.

F1 fuse ok?
K9110 Main relay for DME ok?
Ignition lock and wiring ok?

Hope this helps

GSNam:
Hi Schuppi

Thnks for your reply. To explain a bit more about my problem (not sure how well you know the dakar ).

When I switch on the ignition there is no pre start sequence. The fuel pump does not prime and the coolant light does not flicker.

The fuel pump works as I connected it to 12V. All relays seem to be fine and working. Wiring too. Fuses are good.

Connected the GS911 again for an autoscan and a "no response from controller" message comes up.

Cheers,
H

Sent from my SM-T531 using Tapatalk

Navigation

[0] Message Index

[#] Next page