GS-911 and ezCAN User Forum

General Category => GS-911 => GS-911 Wifi => Topic started by: TRJeff on August 07, 2025, 04:42:40 PM

Title: code help
Post by: TRJeff on August 07, 2025, 04:42:40 PM

I have code  0X4819B  for rear tire sensor what does code tell me?

Title: Re: code help
Post by: botus on August 08, 2025, 01:23:41 PM

did u write that correctly ?

Title: Re: code help
Post by: TRJeff on August 08, 2025, 03:04:01 PM

Yea :-\  I probably did, and after trying to write down code I did a reset I will need to wait and see if code reappears.
problem I have is tire pressures take a very long time to be displayed. rear a lot longer than the front. I am guessing front and rear sensors need replacing.

Title: Re: code help
Post by: botus on August 08, 2025, 06:40:17 PM

Quote from: TRJeff on August 08, 2025, 03:04:01 PM

Yea :-\  I probably did, and after trying to write down code I did a reset I will need to wait and see if code reappears.
problem I have is tire pressures take a very long time to be displayed. rear a lot longer than the front. I am guessing front and rear sensors need replacing.

they do - they have to wake up, can take up to 3 miles often gets worse as the batteries get low...   sometimes they'll be there inside 1/2 mile often takes more

Title: Re: code help
Post by: TRJeff on August 08, 2025, 07:04:19 PM

error codes this am,  0x481f8b   0x481f9b
I have new sensor in hand will replace early next week
 

Title: Re: code help
Post by: TRJeff on August 14, 2025, 05:51:00 PM

removed rear wheel, used GS911 and sensor wake up/learn tool so bike knows new sensor, had old sensor removed and installed new sensor. now at aprox 20 mph both front and rear sensors wake at the same time and bike displays correct tire pressures   joy again