GS-911 and ezCAN User Forum
General Category => Technical => GS-911 => Central Vehicle Electronics/ZFE/GM issues => Topic started by: de walque on April 29, 2025, 03:21:01 AM
-
Hello to all of you, and thanks for your time
So on this bike gs1200adv 2010 i did change the fuel strip level to the float type
Did change two pin on one connector to the zfe module (a high one )
With my gs tool i try to code the zfe module, but it say turn off the switch and wait.
a bar graph will appear... but nothing will happen
i will shot a error like a server fault...
did try it 4 or five time always same result
Do some one have an idea?
Here the vin of the bike: zy04840
Thanks again