GS-911 and ezCAN User Forum

General Category => General Discussion => Topic started by: diondbeer on September 02, 2014, 02:08:05 PM

Title: 10491: Electronic Immobiliser malfunction
Post by: diondbeer on September 02, 2014, 02:08:05 PM
Hi Guys. My F800GS has an issue. When I switched on the ignition switch yesterday the bike made a few werd noises from the various on board servos and then the ignition lights went dead. I removed the battery, it tested faulty. Put in a new unit. Ignition comes on  bit the starter button will not swing the motor. Get an error EWS on the dash and a “10491: Electronic Immobiliser malfunction” error with the GS911 test tool. The error wont clear. Tried the spare key. Can’t clear fault, any ideas?
Title: Re: 10491: Electronic Immobiliser malfunction
Post by: fotodadi on September 02, 2014, 06:05:23 PM
Perhaps the battery "outing" fried your ring antenna?
Title: Re: 10491: Electronic Immobiliser malfunction
Post by: diondbeer on September 02, 2014, 07:35:34 PM
Replaced both pats, it's up and running again. Thought the designers of the electronics would build protection in against these things happening.
Title: Re: 10491: Electronic Immobiliser malfunction
Post by: wmdowdy on September 02, 2014, 08:47:54 PM
I am not understanding what you replaced, you said replaced both parts, what parts by name did you replace?
Title: Re: 10491: Electronic Immobiliser malfunction
Post by: diondbeer on September 03, 2014, 09:48:14 AM
The ring Antenna and the batt.