GS-911 and ezCAN User Forum
General Category => GS-911 Mobile (Bluetooth) => GS-911 => GS-911 Android => Topic started by: savaskayan on March 07, 2014, 01:39:34 PM
-
Hello,
| I am using an android version 1.2 with my GS-911
I have a 2002 R1150gs Adventure.
and Phone (HTC one) and Gs-911 to phone bluetooth connection isn't problem,and the android program show engine faults,clears o.k.
but I dont see ABS faults and clean them.Because Program says about "ABS unit not connected or old then ABS 2"
when I connect GS-911 to laptop isnt problem and I see ABS faults and clean them.
Why I'am not see and clean ABS fault with android version ?
-
I think your GS uses ABS-II, correct? If so then pay attention to the note on the bottom of http://www.hexcode.co.za/products/gs-911/compare
Note: The mobile versions do not support the very old control units (ABS-II, MA2.1, MA2.2), due to their old antiquated protocols and related timing constraints.
-
I think your GS uses ABS-II, correct? If so then pay attention to the note on the bottom of http://www.hexcode.co.za/products/gs-911/compare
Note: The mobile versions do not support the very old control units (ABS-II, MA2.1, MA2.2), due to their old antiquated protocols and related timing constraints.
My friend,
Ms gs-911 is a GS-911blu Enthusiast and not problem connecting with bluetooth.
other controller is ok.
only abs controller function not working.
according to ,I think that It's should clear abs faults,am I right ?
(http://img401.imageshack.us/img401/8756/uqhh.jpg) (http://img401.imageshack.us/i/uqhh.jpg/)
-
Again, read the light grey text below the chart. That describes your bike, doesn't it?