GS-911 and ezCAN User Forum
General Category => Model Specific Discussions => Technical => GS-911 => F Series => Topic started by: jpvSoccer on October 24, 2020, 12:07:50 PM
-
Hi, I am trying to reset all adaptations on my 2002 f650gs dakar. The adaptation reset for the idle air controller actuator errors out with a message about conditions not being right to reset the adaptations.
Does anyone have more detail on what this error is indicating?
Thanks,
John
-
Which of the 2 BMSC you have is reporting that ?, the one with 6000 Series firmware or the one with 8000 Series firmware ?
-
Hi, the 6000 series. I can try the 8000 tomorrow.
-
It would not surprise me if the 6000 Series diagnostics capability was more limited as it was a rush job by BMW, you only need adaptions reset for what you are attempting to do, Idle Actuator will set itself each time ignition is turned off then readjust when ignition is turned back on
-
Hi, I switched the ecu to one with sw version 8000 and was able to clear all adaptations.
I guess the 911 sw could have given an error that I indicatates an unsupported feature rather then the cryptic one I rcvd with version 6000 ecu code.
Anyway, mystery solved.
Thanks for the timely assistance.
John
-
Hi, I switched the ecu to one with sw version 8000 and was able to clear all adaptations.
I guess the 911 sw could have given an error that I indicatates an unsupported feature rather then the cryptic one I rcvd with version 6000 ecu code.
Anyway, mystery solved.
Thanks for the timely assistance.
John
The GS911 was developed after 8000 Series firmware was the normal for the single spark 650GS, there has only been one other thread with a problem of inability to do a reset & that was 5000 series again with a diagnosis index of 2 rather than the 4 of 8000 series