GS-911 and ezCAN User Forum

General Category => Technical => GS-911 => Central Vehicle Electronics/ZFE/GM issues => Topic started by: dsellers on July 27, 2020, 10:48:33 PM

Title: K1600GTLheadlight issue
Post by: dsellers on July 27, 2020, 10:48:33 PM

I'm getting this error code and wonder exactly what it is.
Is it a problem with the headlight itself, or the controller?

1 fault codes found:

E11430   CAN message missing (headlight status from SWE unit)
The fault is currently present.

Thanks,
Dave S.

Title: Re: K1600GTLheadlight issue
Post by: e7navy1999 on July 29, 2022, 11:18:44 PM

Good Afternoon,  What was the final solution?  I am getting an intermittent headlight code but only when I hit bumps

Title: Re: K1600GTLheadlight issue
Post by: Ruan on August 29, 2022, 04:23:41 PM

Hi e7navy1999

The fault code service plan is very vague, you can check it out with the following website, just remember to remove any spaces before searching the fault code:
https://bmwfault.codes/

Check CAN bus, power supply and operation of transmit control unit.

Kind regards
Ruan

Title: Re: K1600GTLheadlight issue
Post by: e7navy1999 on August 29, 2022, 05:00:13 PM

Thanks.  I since replaced my front Genuine OEM BMW K1600GTL Front Level Sensor 37146860843 located just to the left side (rider right side0 behind the front spring.  No more fault codes.  I purchased a used part from ebay for $35usd.  took about 30 minutes to replace, had to remove front wheel but it may be possible without so much effort.  I replaced all my 6 coils at the same time at 100k US Miles.  engine fault code is gone.  Coils 2 and 3 were faulting since two months ago