GS-911 and ezCAN User Forum
General Category => General Discussion => Introduce yourself... => Topic started by: twmichels on May 28, 2019, 01:28:23 AM
-
Hi, just purchased GS-911 for 06 R1200RT
-
Welcome to the forum, plenty of people to assist as you get used to using the GS911
-
Hi, just hooked up GS-911 to '06 R1200RT.
Symptoms rough idle, will not idle without throttle , Error Code:
BMS-K
10010: Lambda (O2) sensor (Cylinder 1)
The fault is currently present.
This fault occurred 2 times.
Logistic counter: 40
Symptom: Signal or value over threshold.
MIL set: No
Fault code history:
Engine speed
1840.00 rpm.
switched o2 sensors, no change in running poorly, same graph results on the cylinder 1 graph flatline.
Any suggestions, also temp is 20% lower on right cylinder? Thanks!
TW
Any suggestions
-
Hello and welcome
Ideas
Please check
Valves adjustment?
Measured values idling position 0 ° TPS functions
Throttle cables synchronously
Connections Ignition coils
pencil coils
Seals of the intake system
-
Hello and thank you,
Ideas
Please check
Valves adjustment? - yes, less than 200 miles ago, 36K mi svc, used JVB excellent video
Measured values idling position 0 ° TPS functions - does the GS-911 measure this ?
Throttle cables synchronously - checked movement, seems to be moving ok
Connections Ignition coils- cleaned connections and replaced plugs
pencil coils- replaced both main coils ( the cylinder one coil had broken in cylinder, discovered when removing plugs )
Seals of the intake system - not sure ? tighten up boots?
Assistance is appreciated, I completed 36 k mi svc, valve adjust, plugs, replaced main coils, oil, transmission, final drive and ABS brake flush, I did not sync the throttle bodies ( fired up and sounded fine).
Around a 150 miles later, during a ride in mountain,s accelerated up hill, power cut out(felt like out of gas ? ). Stopped, visual check, would not start with out throttle roll, would not exceed 40 mph returning home. Throttle needed rolling during traffic stops. Fuel had not been added, ie ran fine before.
Thanks!!! :)
TW
-
Measured values idling position 0 ° TPS functions - does the GS-911 measure this ?
Hello
select engine choose real time values and log this data while engine is running.
In your case just with minimally open throttle (~1500rpm or less) for one minute.
-
Will do as suggested, later this evening, and advise results. Thanks for your feedback :)
TW
-
Hi, ran the real time time values, PDF is attached with results. Much appreciation for assistance. TW
-
Hello
There are no measurements on lambda 2. That's bad.
Think there is a malfunction with this sensor. I would test the connections of the left side lambda sensor.
Possibly swop the sensors and measure again.
Check if the error changed to the right side. Then replace this Lambda sensor
-
Thank you, that makes sense , will try swapping O2 sensors and re-check results for the non voltage. will advise, thanks! //TW
-
Hi Jackarce
copy an entry to insert stupid links.
get your little shovels and please play in another sandbox.
-
apologies
-
Apologies, valve broke, replaced piston, bore, valve head. Thanks for quick responses sir! TW
-
Hello,
Thanks for the feedback.
Good ride and many beautiful miles with your repaired RT