GS-911 and ezCAN User Forum
General Category => General Discussion => Topic started by: BALVIAMBE on August 09, 2017, 11:07:43 AM
-
hi,
have bmw r1200gs just replaced the tpms sensor both front and rear.
did not get any id's with sensor.
how to remove the current sensor id from ecu.
is it possible after removing the id's with gs911 wifi to pickup the new id's and relearn it.
-
HI HAVE ORDERED ATEQ VT31 WILL IT WORK FOR TE ABOVE PROBLEM
-
Yes. most definitely. I use a VT30 and it works 100%
-
Hi,
Jughead thx alot was worried will it work or not.
Autel Maxi TPMS TS401 Auto Diagnostic Tool Scanner Tire Pressure Sensor Decode i have also ordered this tool will it work.
-
hi Jughead,
pls can u describe the way i should start on ateq vt 31. the full way out. pls
-
BWM R1200GS 2016 MODEL.
Can i relearn the sensors without fitting in tire.
using vt 15 and gs911 wifi.
pls assist me and how to do.
-
Hi everyone .
bmw r1200gs 2016 model.
job done by using autel ts 401.
upgrade to new firmware.
use either vehicle selection on ts 401.
US/CN Saturn Astra 2010/01-2010/12 315MHz
US/CN Saturn Astra 2008/01-2009/12 433MHz
US/CN Saturn Astra 2010/01-2010/12 433MHz
it took 3 sec to read id and all info from the sensor, without fitting in tire.
so u know whether the sensor is ok or not.
THE REST IS DONE BY GS911 WIFI.