GS-911 and ezCAN User Forum

General Category => Technical => GS-911 => Engine related issues => Topic started by: kevcollins on May 05, 2018, 06:26:46 PM

Title: F800GS Lambda
Post by: kevcollins on May 05, 2018, 06:26:46 PM
Just got a 2009 F800GS (30000 miles)and ran the GS911 auto scan and getting,

10010 Lambda (02) sensor (cylinder 1)
Fault currently present
Fault occurred 16 times
Logistic counter 40
Sympton : Signal or value over threshold.

Cleared the fault and rode for 20 km. Rechecked and got the above error.

When doing a lambda plot it started at 400mv and over the period 1.5 minutes dropped to 0mv and stayed they.
Valve clearance and plugs etc done at 24000 miles.

Is there any common problem areas.

Thanks.

Title: Re: F800GS Lambda
Post by: schuppi on May 05, 2018, 10:06:04 PM
Hello

If your measurement is right, power supply and connectors are good, then the lambda-sensor will
be faulty.
Replacement is necessary  :)
Title: Re: F800GS Lambda
Post by: Jughead on May 07, 2018, 07:10:43 AM
Yes, as Schuppi says, I would check the connector first.

Unplug it, make sure it i clean, apply some electrical contact spray, and re-connect.  Hopefully that will resolve the issue.
Title: Re: F800GS Lambda
Post by: kevcollins on May 07, 2018, 01:00:04 PM
Thanks for your guidance and help.

I will report back when done.
Title: Re: F800GS Lambda
Post by: kevcollins on May 18, 2018, 05:14:28 PM
Just replaced the sensor and completed a roadtest. Problem solved so far and totaly different bike.

Thanks for your help.