GS-911 and ezCAN User Forum

General Category => General Discussion => Topic started by: Mornay on May 19, 2020, 08:52:03 AM

Title: GS-911 V2004.1 (April/May 2020) software updates available
Post by: Mornay on May 19, 2020, 08:52:03 AM
Hi everyone,

Its that time of the year again. Latest GS-911 software update includes, but not limited to, the following:


Note that this is a ongoing project - see the function chart to find out what has been implemented already and what still needs to be done.

For a comprehensive list of changes, visit this link:

https://www.hexcode.co.za/may-2020-software-updates-available

Regards,
Mornay
Title: Re: GS-911 V2004.1 (April/May 2020) software updates available
Post by: 2wheeler on June 13, 2020, 10:06:00 AM
Do's a new software update include all previous updates - or must I do all updates since my last one?
Title: Re: GS-911 V2004.1 (April/May 2020) software updates available
Post by: Jughead on June 13, 2020, 01:49:31 PM
Quote from: 2wheeler on June 13, 2020, 10:06:00 AM
Do's a new software update include all previous updates - or must I do all updates since my last one?

Just update.  No need far all past updates.
Title: Re: GS-911 V2004.1 (April/May 2020) software updates available
Post by: loneranger on June 26, 2020, 06:06:01 PM
Careful with pulling the trigger on updates.  I updated my GS911 this morning and now it no longer works.  User interface just sits there grinding away and will not load.
Title: Re: GS-911 V2004.1 (April/May 2020) software updates available
Post by: Jughead on June 26, 2020, 07:07:34 PM
Quote from: loneranger on June 26, 2020, 06:06:01 PM
Careful with pulling the trigger on updates.  I updated my GS911 this morning and now it no longer works.  User interface just sits there grinding away and will not load.

Just retry the update.  No one else has had an issue with the latest updates.