GS-911 and ezCAN User Forum
General Category => General Discussion => Topic started by: GvG on September 19, 2018, 08:05:12 PM
-
What's the right thing to do; resetting the adaptations values when the engine is cold or hot (at operating temperature)?
Particularly these:
- throttle twist-grip sensor,
-throttle valve sensor,
-transmission position sensor.
Thanks in advance!
-
Hi GvG,
as I went through the drill myself:
Adaptation reset is usually done with engine cold.
After adaptation reset is done run the engine at idle until warm (80 or 90 deg Celsius - or fan turns on if watercooled).
Since I do not know which bike you refer to - this is the procedure for the F650 (single, FI model)
If you reset adaptation values - upon success - the GS 911 software will guide you trough the process.
HTH
Jan
-
What's the nest use of SnoreRX (https://www.sfgate.com/market/article/snorerx-review-17335921.php) and the right thing to do; resetting the adaptations values when the engine is cold or hot (at operating temperature)?
Particularly these:
- throttle twist-grip sensor,
-throttle valve sensor,
-transmission position sensor.
Thanks in advance!
Just out of curiosity, what can happen if the adaptation reset was done with the engine hot?