GS-911 and ezCAN User Forum
General Category => R Series => Model Specific Discussions => Technical => GS-911 => R1100 models => Topic started by: markinaz on April 23, 2015, 10:29:11 PM
-
What does this mean?
2003 K1200GT. ABS is not functioning. No tail or stop lighting. No speedometer. When the connector to the ABS unit is unplugged, k-line 2 status reports OK. Plugged in, status changes to "stuck high".
TIA
Mark
-
Dead ABS :'( ,
A defective ECU can hold the line high or low, on your model the ABS must be on the second diag pin of the diagnostics connector hence the message K Line 2
-
Thanks for the info, a defective ABS controller was what I feared.
What does "stuck high" mean? Pressure? Current? Voltage? Something else?
Mark
-
Basically stuck at 12v, stuck low would be at 0v, also checked with a Pro mechanic mate of mine, not unusual in the cars at least
-
Thanks!