GS-911 and ezCAN User Forum
General Category => Technical => GS-911 => Engine related issues => Topic started by: baja65 on July 24, 2022, 11:18:20 PM
-
Hello All
I have a 2007 R1200RT and was riding the other day and put fuel in it and about a mile down the road the bike just quit.
I did hook-up the GS 911 and I have no fault codes.
Is the GS 911 able to look at the Immobilizer circuit? if so What might I be doing wrong? Any help would be great
Thank you
Baja65 / Fred K
-
Update:
I did unplug the Immobilizer ring and it did show up as a fault code, I plugged it in and the code goes away
but still no start.
-
Fuel pump relay?
-
Petrol station pillar swapped ?
-
Start with "Simple stuff" Bad fuel? water in tank? Use GS911 to check fuel pump.
-
it is best to start with a complete auto-scan
-
My bet would be on either bad fuel (water) or the fuel pump itself.
A faulty fuel pump controller will bring up an error, a bad fuel pump won't. As has been mentioned, start with a fuel pump test. If you can hear the pump running, then you would have bad fuel.
-
My bet would be on either bad fuel (water) or the fuel pump itself.
geometry dash subzero (https://geometrydashsubzero.net)
A faulty fuel pump controller will bring up an error, a bad fuel pump won't. As has been mentioned, start with a fuel pump test. If you can hear the pump running, then you would have bad fuel.
Can you let me know what the results are?