GS-911 and ezCAN User Forum

General Category => Technical => GS-911 => Central Vehicle Electronics/ZFE/GM issues => Topic started by: GlobalriderTrev on April 28, 2019, 01:33:08 AM

Title: Parking light fault
Post by: GlobalriderTrev on April 28, 2019, 01:33:08 AM
I recently replaced my parking light bulb from incandescent 13.5V 5w to LED 12.8 V .5w. After doing this, I got the LAMPF fault on my control panel. I hooked up my GS911 to clear the fault on the control panel, but was not allowed to clear the fault.
Below is the text of the GS911 report.
Is there any reason that I can't clear this??

Fault Codes : 1
|
41789 : Park light malfunction, open-circuit
Currently present : YES
Symptom : No signal or value
Engine warning light (MIL) : NO
Frequency count : 1
Logistic(Healing) count : 40
..Fault Code History :
....Record number : 0
....Odometer : 8755.5 mls
....Battery Voltage : 12.00 V
....Speed : 0.0 mls/h
Title: Re: Parking light fault
Post by: WayneC on April 28, 2019, 03:00:22 AM
It would help to know the model & year of the machine  ;D

In general terms though where circuits are monitored by an ECU fitting a component with lower or higher current value will generate a fault code, & where a fault code indicates the fault is "currently present" then clearing the code would only generate another fault code until the fault is resolved
Title: Re: Parking light fault
Post by: GlobalriderTrev on April 28, 2019, 03:30:48 PM
Hello Wayne,

Yes, you are correct. It is an 08 R1200 GSA. Seems like I'll have to put back the incandescent bulb if I want to clear the fault. Since the LED bulb isn't the correct voltage.

Thanks for your reply.
Title: Re: Parking light fault
Post by: WayneC on April 28, 2019, 03:55:16 PM
Hello Wayne,

Yes, you are correct. It is an 08 R1200 GSA. Seems like I'll have to put back the incandescent bulb if I want to clear the fault. Since the LED bulb isn't the correct voltage.

Thanks for your reply.

It is not a question of the voltage, you state the correct voltages for both, it is a question of the current, you can see that in the wattage difference from 5 watts down to 0.5 watts for the LED ie 10% of the incandescent bulb so current is reduced from 0.4 amps down to 0.04 amps

On many of the modern machines you have to code the dash for LED globes so they dont generate faults