GS-911 and ezCAN User Forum

General Category => General Discussion => Topic started by: BlackSmith on March 05, 2024, 09:39:59 AM

Title: Any insights
Post by: BlackSmith on March 05, 2024, 09:39:59 AM

I own a 2010 F800ST and recently changed both tires. The RDC sensors were missing, likely removed by the previous owner. When connecting my GS-911, I received a message that makes me suspect the original purchaser didn't opt for the RDC option. Can this message indicate the absence of the RDC module? I've read adding this option later may not work due to the bike computer not recognizing non-factory-installed sensors. Thanks for any insights.

Title: Re: Any insights
Post by: GS Jim on March 05, 2024, 06:54:32 PM

When you do a auto scan, under the section called "Bike Information" there is a list that is called  "Vehicle Order" If the bike came from the factory with it RDC should show in that list. Also you would have the tire pressure monitor showing under "Controller Summary" And then it should have its own section also.
You stated "I received a message that makes me suspect the original purchaser didn't opt for the RDC option" What was the actual "message"?

Title: Re: Any insights
Post by: principalhorror on March 25, 2024, 06:47:51 AM

Thank you. I have solved my problem

Title: Re: Any insights
Post by: schuppi on March 28, 2024, 01:29:47 AM

Quote from: principalhorror on March 25, 2024, 06:47:51 AM

Thank you. I have solved my problem

OMG, I don't think so ;D

Title: Re: Any insights
Post by: GS Jim on March 28, 2024, 01:37:32 AM

Good one Schuppi, thanks for the laugh.