Author Topic: Set/Modify current monitoring limits  (Read 6262 times)

zamzon

  • Newbie
  • *
  • Posts: 4
  • Karma: +0/-0
Set/Modify current monitoring limits
« on: March 26, 2015, 07:55:34 AM »
Dear tweakers, drivers and hackers,

Is there a know way of adjusting the current limits observed by the ZFE for
  • AUX connector
  • Cartool connector
  • Rear Lights
  • Head Lights
  • etc.


And please enlighten me: do you all have to enter the verification code and also answer these verification questions for every post here????  This is sick.

Thomas

TAJL

  • Newbie
  • *
  • Posts: 19
  • Karma: +0/-0
Re: Set/Modify current monitoring limits
« Reply #1 on: March 28, 2015, 03:20:36 PM »
I had to enter the verification code initially which was very annoying but it stopped asking for it before I stopped visiting this site.  ;)

Dann

  • Jr. Member
  • **
  • Posts: 71
  • Karma: +0/-0
Re: Set/Modify current monitoring limits
« Reply #2 on: April 15, 2015, 05:10:46 AM »
It's not asking me anymore  :D
« Last Edit: April 15, 2015, 02:39:04 PM by Dann »

Xchallenge

  • Jr. Member
  • **
  • Posts: 69
  • Karma: +1/-0
Re: Set/Modify current monitoring limits
« Reply #3 on: April 15, 2015, 09:26:38 AM »
And please enlighten me: do you all have to enter the verification code and also answer these verification questions for every post here????
No. It's been so long since I joined so I don't remember but I think the forum was then so obscure that anti-spam wasn't even needed.
Quote
This is sick.
The spamming industry is sick and it's consequences are a pain but unfortunately necessary...

I've seen global forums with +100k users becoming virtually unusable for weeks because of spam attacks from a few individuals. That is in my opinion much worse than new users having to verify themselves up to the point where most spammers are filtered away.

Welcome here and enjoy your GS-911!

Unfortunately this thread may now serve as a reference manual for spammers on what is required to sneak in. :'(

@Dann, could you please change the part where you mention a specific number?