General Category > General Discussion

Stops logging at different rpm

(1/1)

Sven72:
I have been live logging to try find a fault at around 11000 rpm on my S1000rr and the program doesnt log all the way to the rev limiter.
If i deselect all sensors except one it works but as soon as there is more than one selected  it stops logging after a few secs.

In the three logs i have have it stops once on 8k and twice just above 10k rpm.

Any ideas what is happening?

WayneC:
Which version of GS911 is it and which software/firmware version are you using ?

Sven72:
Hi Wayne, it's the usb version and the latest software as I only took delivery of it on Monday.

WayneC:
OK, I did considerable testing of real time recording on my 650GS which is a little bit of a different beast to yours, it does not seem to like RPM that high  ;D  and I could not get it to fail so I would suggest you lodge a support ticket with Hexcode. I was using the WiFi as part of the testing of it and all up I must have a few hours of logs. glitches like you seem to have were what I was looking for and I failed to break it  :'(

Sven72:
Great tx for the feedback, different bikes different range of rpm. So Yes I have lodged a ticket with hexcode.

Navigation

[0] Message Index