General Category > Introduce yourself...

Helo from Washington Crossing Pa. USA

<< < (2/2)

Riverfurm:
Maybe I misunderstand the way the Wi-Fi works. When I use the phone app I connect to the GS911 through it's Wi-Fi connection. When I use it at home the GS911 should be in my network list (like the other computers and Wi-Fi printer in the house). But when I go out to my garage the house Wi-Fi has a poor signal, so that's when I use the Wi-Fi repeater. they have different SSID and passwords.

Am I correct in believing that the GS911 should show up on my list of devices on my home or garage network?

The code on the bike shows up only on startup after I have been riding for a while.  Never while riding or when hitting bumps.

The next purchase I need to make are for the factory manuals (CD)

Thanks for the help

WayneC:
Where you have a repeater it would be normal to use the same SSID on the primary and repeater Access Points so as you walk through the house to the garage the device can transfer from one base station to the other

If you have a different SSID in the Garage then you would need to set up 2 separate networks on the GS911 and use the button to move from one to another

Riverfurm:
After a few hours I got my GS-911 on my garage network. I must of had an issue with some software I downloaded. I uninstalled all the software and reinstalled it and everything worked as designed. I have my garage network running and was able to connect to it through two computers that are on the network. I was able to connect to it through the D2D option and my phone app works too.

Earlier I had did an autoscan and found allot of codes in the system. Most due to me disconnecting item to install accessory. I deleted all the codes and reset my service reminder. It seems to me the K1600GTL runs smoother and shifts smoother ::) 

Thanks for the help Waynec

Navigation

[0] Message Index

[*] Previous page