General Category > GS-911 Wifi

GS 911 wifi HELP PLEASE

(1/4) > >>

pacsman:
I received the new GS911 wifi. Went through the download, registration and checked for updates. I have not been able to get my unit and K1200LT to see each other. I get a error every time I select K1200LT.

On my 2011 and 2014 RT I am able to see the bike, but on both bikes when I try to read and fault or ECU information, I get error that run switch is not on, or faulty wiring, or something about unit not connected.

What am I doing wrong? it should not be this hard to connect. I do not see any user manual online for the new wifi unit to try reading to figure it out.

Thanks,
Troy

WayneC:
Do you have a PC and the PC software set up to confirm correct operation using the unit in USB mode ?

pacsman:
Wayne,

How do I check this? I see  nothing on the quick start that came with it, or nothing about that on the website for the wifi unit. Also it is the same scenario and errors when I just use the gs unit and iphone. I connect the iphone to the gs network with the same results.

WayneC:
I would isolate whether it is a basic hardware fault or firmware/WiFi by plugging the unit into A USB port and downloading and installing the PC software then using that into the bike. If that works then I know the hardware aspect is OK

I guess I am spoilt in having the Notebook to take out to the bike, I have already tested the WiFi unit using both USB/PC and WiFi so I know it is all OK
on the unit I have here

pacsman:
that's what I did. took laptop out connected via usb cable. not able to see the LT bike. Can see the 2 RT's, but cant do anything with it. Tried using it via wireless also same situation. So frustrated.

Navigation

[0] Message Index

[#] Next page