I installed a used mechanism for the windshield with only 6,500 miles on it. When I used the switch to raise the windshield it went up just fine. Problem is it now is stuck in the up position. I used my GS-911 to run a calibration it came back with the message "A negative response was received from the vehicle. The preconditions or sequence order was not met for this controller." That is all.
So questions are:
What does that message mean?
Could a fuse have been blown while I ran the windshield up, If so where is it?
If there is no fuse, did the buss shut it down, if so how do I turn it back on?
What other conditions (not being met) is GS-911 talking about?
I'm stuck just like my windshield and haven't been able to find much on the subject.
Any help would be appreciated.
