Hi all, this is for a 2004 R 1150 R and we are with a professionnal GS-911 model
After connecting the GS-911 to the bike for an autoscan, I decided to go threw each feature to check. Arrived on Hall Sensor Signal Test, I believed (because I don't really remember if I did it or not) I pressed the Start button but finally didn't went threw the whole test. And now the bike won't start, I have a lack of pressure on the injectors, just like the bike was always in the state of test where it's impossible to start the bike.
So I replug after the GS-911 to redo the whole test, with the blue squares on the display when correct. And the bike will still not start. And there is a lack of pressure on the injectors.
During the test I upgraded my GS-911 to the latest beta version and, today, I'm not sure it was a good idea because the auto scan just gives me a very small amount of information...
AutoScan Report
GS-911 version: 1404.6 Datapack version: 1.8 Serial Number: GS60335915 Registered to: me ;-)
Date: 02/06/2014 Time: 20:28:22
Motorcycle Information
VIN:
Mileage: Not available
Motronic MA2.4
Motorcycle Variant: R1150R/GS ECE+US
Part No.: 7658618
Bosch Part Number: 0261207869
ECU Software Number: 1037369658
ECU coding variant: 0
ECU program version: 48000400
Manufacturer: Bosch
HWOE No.: 25406831
Idle Actuator: No
Emissions control type: Lambda
2 fault codes found:
821 Hall sensor 1, no signal – this fault will always occur if engine not running or engine not cranked before reading Fault codes.
The fault is currently present.
901 Hall sensor 2, no signal – this fault will always occur if engine not running or engine not cranked before reading Fault codes.
The fault is currently present.
Integral ABS
Part No.: 7660909
Hardware Version No.: 17
Manufacturing date(YYYY/mm/dd): 2004/03/27
HWOE No.: 25322775
Software Version: 5.1.6
Manufacturer: FTE
Part No.: 37012056
Serial No.: 25922
Host date(YYYY/mm/dd): 2003/02/17
Control computer date(YYYY/mm/dd): 1999/09/10
Control computer version: V01.63
EPROM version: 64
Control computer ROM checksum 78
No fault codes foundWith the previous version I had, in the Realtime Data, the Fuel pump was Off. Is it normal ? How could I change that?
First of all I need the bike to run, so if anybody have an idea to bring back pressure in those injectors, I'll be happy
![Wink ;)](http://forum.hexcode.co.za/forum/Smileys/default/wink.gif)