General Category > General Discussion

2002 R1150R brake bleed test

(1/1)

Ten32taz:
Does anyone know if the brake servos are supposed to activate during a brake bleed test?  When I did the test, started by slowly pulling the front brake, no servo activation and the pressure only reached around 10 bar. Obviously I got a failed test as it was nowhere near the suggested 100 bar. Help appreciated thanks.

schuppi:
Hello

During the bleed test, the pumps are not running. You must set the front brake lever to its furthest reach
and then pull the lever toward the handlebar with all your strength.
Then the required minimum pressure can be achieved.

Navigation

[0] Message Index