Author Topic: Fuel strip to float conversion R1200gsa 2007  (Read 1268 times)

landydave

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
Fuel strip to float conversion R1200gsa 2007
« on: August 12, 2023, 11:42:48 PM »
Hi. New to the gs-911 so please be gentle.
My fuel strip has failed again so I want to convert to float. Please can anyone tell me if the gs-911 can perform the necessary ecu change once the wiring pins have been correctly relocated?

schuppi

  • Hero Member
  • *****
  • Posts: 548
  • Karma: +21/-0
Re: Fuel strip to float conversion R1200gsa 2007
« Reply #1 on: August 13, 2023, 12:35:05 AM »
Hello
I have not yet done such a conversion,
but yes, as the function chart describes it,
the ZFE can be recoded.

ZFE Configuration    Fuel Sensor    Switch between Lever type and Film type fuel sensors
Schönen Tag
Wolfgang
                                       talk less, drive more

Skim

  • Jr. Member
  • **
  • Posts: 67
  • Karma: +0/-0
Re: Fuel strip to float conversion R1200gsa 2007
« Reply #2 on: August 13, 2023, 09:48:39 AM »
I could not find a R series float that would fit the RT tank. (2010)

Did the pin swop, fitted a 39 Ohm resistor and did the change from 'film' to 'lever' with the GS-911.

Worked.

Good luck.

botus

  • Beta testers
  • Full Member
  • *
  • Posts: 164
  • Karma: +3/-0
Re: Fuel strip to float conversion R1200gsa 2007
« Reply #3 on: September 04, 2023, 11:17:45 AM »

tghtenuion

  • Newbie
  • *
  • Posts: 3
  • Karma: +0/-0
Re: Fuel strip to float conversion R1200gsa 2007
« Reply #4 on: November 08, 2023, 04:35:02 AM »
I put on the Fuel sensor strip today and tried it out for the first time. I thought something was wrong, but after a few hundred feet, the fuel level showed up and the MPG and range worked fine. We'll just have to wait and see what happens.