General Category > Technical
Coding R1200 GS for change from strip sensor to float.
marknorthwood:
I am about to change my 2008 GS strip fuel level sensor to a float. I am following the guide in: https://www.ukgser.com/forums/showthread.php/509657-Fuel-strip-to-float-conversion-complete-guide
This describes using the MotoScan software to re-code the bike to know there is a float, so that there is no need to buy a secondary interface module.
I have had the GS911 unit for a while and think it is a great unit, but cannot figure out a way to do the same with it. Is it possible? I have tried searching, but can't find any details here.
motoman58:
I have the same thought on my 2008 K 1200 S, change from strip sensor to float from 2009 K 1300 S as described here: https://www.k-bikes.com/threads/fuel-strip-thought.47211. They also refer to Motoscan for coding. So any news how to do with GS-911?
Jughead:
You cannot do the required coding with the GS911.
marknorthwood:
So it would seem. It's a shame that I have to purchase another software only solution, using nothing more than a generic OBD dongle to achieve it though.
Outsider:
November 2020 update info page says "- Add K24 fuel strip to float retrofit function" so fingers-crossed.
https://www.hexcode.co.za/november-2020-firmware-upgrades-available
I've not updated yet, so cannot confirm.
Navigation
[0] Message Index
[#] Next page
Go to full version