Author Topic: Measure the pressure sensor...  (Read 15857 times)

Jughead

  • Beta testers
  • Hero Member
  • *
  • Posts: 768
  • Karma: +51/-3
    • Dual Sport Motorcycle Clinic
Re: Measure the pressure sensor...
« Reply #30 on: May 22, 2020, 11:30:21 AM »
Yoh!  Difficult question.  Unfortunately with these pumps it is very much a matter of trial and error.  I would replace the sensor to start with.

knappen

  • Newbie
  • *
  • Posts: 40
  • Karma: +0/-0
Re: Measure the pressure sensor...
« Reply #31 on: May 22, 2020, 11:52:34 PM »
i replaced the whole ABS unit/pump i hade a used one...

But now i wonder how does the Bleeding work with the GS-911?  I run the software... right? But do i have to open any nipple to let the air out... if so... witch one? The ones on the wheels or on the ABS unit( witch one of the 6 ? )

mike d

  • Full Member
  • ***
  • Posts: 133
  • Karma: +3/-0
Re: Measure the pressure sensor...
« Reply #32 on: May 23, 2020, 11:15:49 AM »
The GS-911 Bleed test is just that. A test to see if you have any trapped air in the system AFTER you performed the physical bleed operation.

The following is just one of a number of explanations on how to perform the actual bleed sequence.

https://www.ukgser.com/technical/nick/Brake%20bleeding%20(All%20BMW%20EVO%20systems,%20%2704-%2707).pdf

Mike

Jughead

  • Beta testers
  • Hero Member
  • *
  • Posts: 768
  • Karma: +51/-3
    • Dual Sport Motorcycle Clinic
Re: Measure the pressure sensor...
« Reply #33 on: May 25, 2020, 06:49:10 AM »
The GS-911 Bleed test is just that. A test to see if you have any trapped air in the system AFTER you performed the physical bleed operation.

The following is just one of a number of explanations on how to perform the actual bleed sequence.

https://www.ukgser.com/technical/nick/Brake%20bleeding%20(All%20BMW%20EVO%20systems,%20%2704-%2707).pdf

Mike

Agreed.  This is one of the best write-ups for bleeding these systems.

knappen

  • Newbie
  • *
  • Posts: 40
  • Karma: +0/-0
Re: Measure the pressure sensor...
« Reply #34 on: May 25, 2020, 04:06:15 PM »
okay thanks guys for the help :)