General Category > Introduce yourself...

Hello from Northern Colorado

(1/3) > >>

twmichels:
Hi, just purchased GS-911 for 06 R1200RT

WayneC:
Welcome to the forum, plenty of people to assist as you get used to using the GS911

twmichels:
Hi,  just hooked up GS-911 to '06 R1200RT.
Symptoms rough idle, will not idle without throttle , Error Code: 
BMS-K
10010: Lambda (O2) sensor (Cylinder 1)
The fault is currently present.
This fault occurred 2 times.
Logistic counter: 40
Symptom: Signal or value over threshold.
MIL set: No
Fault code history:
Engine speed
1840.00 rpm.

switched o2 sensors, no change in running poorly, same graph results on the cylinder 1 graph flatline.

Any suggestions, also temp is 20% lower  on right cylinder?  Thanks!

TW

Any suggestions

schuppi:
Hello and welcome

Ideas
Please check
Valves adjustment?
Measured values idling position 0 ° TPS functions
Throttle cables synchronously
Connections Ignition coils
pencil coils
Seals of the intake system

twmichels:
Hello and thank you,

Ideas
Please check
Valves adjustment? -      yes, less than 200 miles ago, 36K mi svc, used JVB excellent video
Measured values idling position 0 ° TPS functions -   does the GS-911 measure this ?
Throttle cables synchronously -   checked movement, seems to be moving ok
Connections Ignition coils-  cleaned connections and replaced plugs
pencil coils-   replaced both main coils ( the cylinder one coil  had broken in cylinder, discovered when removing plugs  )
Seals of the intake system -  not sure ?  tighten up boots?

Assistance is appreciated, I completed 36 k mi svc, valve adjust, plugs, replaced main coils, oil, transmission, final drive and ABS brake flush, I did not sync the throttle bodies ( fired up and sounded fine).
  Around a 150 miles  later, during a ride in mountain,s  accelerated up hill, power cut out(felt like out of gas ? ). Stopped, visual check, would not start with out throttle roll, would not exceed 40 mph returning home.  Throttle needed rolling during traffic stops.  Fuel had not been added, ie ran fine before.

Thanks!!! :)


TW

Navigation

[0] Message Index

[#] Next page